Brother International ZE-856A Instruction Manual - English and Spanish - Page 114
Setting the zigzag width for start backtack stitches additional DIP switch function, Turning
View all Brother International ZE-856A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 114 highlights
7. USING THE OPERATION PANEL 7. VERWENDUNG DER BEDIENUNGSTAFEL 7. UTILISATION DU PANNEAU DE COMMANDE 7. USO DEL TABLERO DE CONTROLES I Setting the zigzag width for start backtack stitches (additional DIP switch function) (Be sure to turn off the power before changing any of the DIP switch settings. Refer to page 171.) Zigzag width for section A start backtack stitches (3.0mm) When DIP switch 2-5 inside the control box is set to OFF, the zigzag width for start backtack stitches can be set separately from the normal zigzag width. (You must set the end backtack zigzag width at this time too. Be sure to make this setting if carrying out end backtack sewing too.) Zigzag width for section B start backtack stitches (1.5mm) 1451M Zigzag width er 1452M 1. Press the start backtack key q. • The indicator w will illuminate and the start backtacking function will turn on. • The AB indicator e will illuminate and the number of start backtack stitches will appear in the LED display r. 2. To change the number of start backtack stitches, use the ĦĤ selection keys t to change the setting value. e ry t Zigzag width for section A Zigzag width for section B w q 1453M wq 1454M 3. Press the start backtack key q once more. • The indicator w and the AB indicator e will remain illuminated, and the tack width indicator y will also illuminate. • The zigzag width for the start backtack stitches will appear in the LED display r. (For example, AA AA indicates widths of 3.0 mm for section A and 1.5 mm for section B and that start backtacking will be carried out.) 4. Use the ĦĤ selection keys t to change the zigzag widths. 5. Start backtacking will be carried out when the treadle is depressed. Turning the start backtack function on and off Carry out the following settings after the thread has been trimmed (or after the treadle has been depressed backward for the 855A-A0 [ ]). • The condition changes as shown below each time the start backtack key q is pressed. • Start backtacking is carried out when the start backtack indicator w is illuminated. * The zigzag width at the sewing start will change when the start backtack indicator w is turned on and off, and so the needle bar will move at this time by the amount of the difference. w Illuminated Illuminated Off q Zigzag width display, etc. 1448M Number of start backtack stitches 1449M Zigzag width for start backtack stitches 1455M Zigzag width display 1450M 95 ZE-855A,856A