Sharp BP-70C45 Color Advanced and Essentials BP Series Operating Manual - Page 37

BEFORE USING THE MACHINE►HOW TO PLACE THE ORIGINAL DOCUMENT GLASS This section describes the steps for setting the original on the document glass. • Close the automatic document feeder slowly. Abruptly closing the automatic document feeder may damage it. • Take care that your fingers are not pinched when closing the automatic document feeder. Allowed original sizes Minimum original size Standard size (Minimum size that can be automatically detected) 8-1/2" (longitudinal) × 5-1/2" (transversal) A5: 210 mm (longitudinal) × 148 mm, (transversal) Non-standard size (Minimum size that can be specified manually) 1" (longitudinal) x 1" (transversal) 25 mm (longitudinal) x 25 mm (transversal) Maximum original size Standard size (Maximum size that can be automatically detected) 11" (longitudinal) x 17" (transversal) A3: 297 mm (longitudinal) x 420 mm (transversal) Non-standard size (Maximum size that can be specified manually) 11-5/8" (longitudinal) x 17" (transversal) 297 mm (longitudinal) x 432 mm (transversal) • When the original is a non-standard size, see the appropriate explanation below for the mode you are using. • COPIER: "STORING FREQUENTLY USED ORIGINAL SIZES (page 3-31)" • FAX: "SPECIFYING THE ORIGINAL SCAN SIZE USING NUMERIC VALUES (page 5-46)" • IMAGE SEND: "SPECIFYING THE ORIGINAL SCAN SIZE USING NUMERIC VALUES (page 6-72)" 1 Open the automatic document feeder. 2 Load the paper with the print side facing down. Place the original face down and align the top left corner of the original with back left (at the tip of the mark ) of the document glass. Original size detector Mark Document glass scale Y X Do not place any objects under the original size detector. Closing the automatic document feeder with an object underneath may damage the original size detector or disable correct detection of the original size. 1-34