Sharp BP-70C45 Color Advanced and Essentials BP Series Operating Manual - Page 993

TROUBLESHOOTING►GENERAL PROBLEMS THE EJECTED ORIGNALS ARE NOT ALIGNED NEATLY (AUTOMATIC DOCUMENT FEEDER) Check Is the original set correctly?  Depending on the condition of the original, the type of paper, the temperature at the time of use, and the humidity environment, the ejected originals may not be aligned neatly.  Solution ■ Depending on the condition of the original, the type of paper, the temperature at the time of use, and the humidity environment, the ejected originals may not be aligned neatly. It may be improved by the following settings. • For copying: Set the resolution to 600x600dpi • For scan transmission: use "Preview" AUTOMATIC DOCUMENT FEEDER (page 1-30) THE PAPER MISFEEDS Check Is a torn piece of paper remaining in the machine? Is too much paper loaded in the tray? Are multiple sheets feeding at once? Are you using paper that is not within the specifications? Are the bypass tray guides adjusted to the width of the paper? Is the bypass tray extension guide pulled out? Is the bypass feed roller dirty? Is A5/A6 (5-1/2" x 8-1/2") size paper loaded? Is the paper size specified? Did you add paper to the tray?  Solution ■ Follow the instructions in the touch panel to remove all paper. ■ Reload the paper. Load no more than the maximum number of sheets and do not exceed the indicator line. LOADING PAPER (page 1-11) ■ Fan the paper well before loading it. ■ Use SHARP-recommended paper. Using paper that is for other models or special paper that is not supported may result in misfeeds, creases, or smudges.  - "SUPPLIES" in Start Guide For paper that is prohibited or not recommended, see IMPORTANT POINTS ABOUT PAPER (page 1-11). ■ Adjust the bypass tray guides to the width of the paper so that they slightly contact the sides of the paper. LOADING PAPER INTO THE BYPASS TRAY (page 1-22) ■ When loading large-size paper, pull out the extension guide. LOADING PAPER INTO THE BYPASS TRAY (page 1-22) ■ Clean the surface of the bypass feed roller. CLEANING THE BYPASS FEED ROLLER (page 1-72) ■ When loading A5/A6 (5-1/2" x 8-1/2") size paper, place the paper in the horizontal (A5R/A6R (5-1/2" x 8-1/2"R)) orientation. (For A5, Tray 1 or the bypass tray can be set in portrait orientation (A5).) ■ If you are using a non-standard size, be sure to specify the paper size. If the size of paper loaded into a tray was changed, be sure to check the paper size setting.  "Settings" → [System Settings] → [Common Settings] → [Paper Settings] → [Paper Tray Settings] → [Tray Registration] ■ When adding paper, remove any paper remaining in the bypass tray, combine it with the paper to be added, and reload as a single stack. If paper is added without removing the remaining paper, a misfeed may occur. Do not add paper other than the bypass tray. 10-10