Sharp BP-70C45 Color Advanced and Essentials BP Series Operating Manual - Page 864

SETTING MODE►SYSTEM SETTINGS ECM When you send a fax, noise on the line may occasionally cause distortion of the image. You can enable ECM (Error Correction Mode) to automatically resend only the part of the image that was distorted. Factory default settings: Enable If the receiving machine is a Super G3 machine, ECM will always operate, regardless of this setting. Digital Line Network When this setting is enabled, the send level will be 15 dB or less when you connect to a digital line. Factory default settings: Disable Distinctive Ring Detection If multiple telephone numbers have been assigned to your telephone line, the number called can be identified by its ringing pattern. By using one number for voice calls and another number for faxes, you can tell which type of call you are receiving by the ringing pattern. You can set your machine to automatically receive faxes when your fax number is called by setting the pattern that corresponds to your fax number. Factory default settings: Disable Send Setting Make settings related to fax transmission. Auto Reduction Sending Setting Set to automatically reduce according to the chart paper size of the other party. If you cancel the setting, the actual size will be sent without automatic reduction. In this case, part of the original may not be printed because it does not match the size of the chart paper of the other party. Factory default settings: Enabled Rotation Sending Setting When transmitting an image that is one of the following sizes, this function rotates the image 90 degrees counterclockwise. (The setting can be configured separately for each size.) 8-1/2"x11", 5-1/2"x8-1/2"R, A4, B5R, A5R, 16K Factory default settings: All enable 8-1/2" x 11"R and A4R size images are not rotated. Quick On Line Sending When this setting is enabled, the machine starts transmitting a fax as soon as the first page is scanned. Transmission takes place at the same time as the remaining pages are being scanned. Factory default settings: Enable Printing Page Number at Receiver When the transmitted image is printed by the receiving machine, the page number can be added to the top of each printed page. Factory default settings: Enable 9-90