Sharp BP-70C45 Color Advanced and Essentials BP Series Operating Manual - Page 850

SETTING MODE►SYSTEM SETTINGS Sending the same image sent in Fax mode Enable this when sending by broadcast transmission in Fax and other modes and you want to send the same image in all modes. If this function is disabled, an image specified with each Scan Setting is sent to E-mail, FTP, Desktop, and Network Folder. When an Internet Fax address is included in the addresses, the same image is sent regardless of this setting. Factory default settings: Disable Be sure to press Next Address Key ([+]) before selecting the next address. Set whether or not the Next Address ([+]) key must be pressed before an address is added for a multi-address job such as broadcast transmission. Factory default settings: Disable Disable Switching of Display Order Disables to change the order of display (search number order, ascending, descending). Once set, the display sequence is not changed. The display order will remain fixed at the order that is in effect when this setting is enabled. Factory default settings: Disable Hold Setting for Received Data Print This function holds received faxes and Internet faxes in memory without printing them. The faxes can be printed by entering a password (factory default setting: 0000) with the numeric keys. Factory default settings: Disable Password When [Hold Setting for Received Data Print] is enabled, enter the password (4-digit number). These settings can only be configured when there is no received data in the machine memory (excluding data in a confidential or relay broadcast memory box). Default Verification Stamp This is used to enable or disable the default setting. Enable this to always affix the verification stamp on the original that has already been scanned using the automatic document feeder. Configure the setting for each of the following items: • E-mail/Scan/Data Entry • Fax/Internet Fax Factory default settings: Disable Erase Width Adjustment This is used to set the default erase width for erase function. Specify a value from 0" (0 mm) to 1" (25 mm) in increments of 1/8" (3 mm) for both edge erase and center erase. Factory default settings: Edge Clearance Width:1/2" (10mm), Center Clearance Width:1/2" (10mm) Time Specified Output of Received Data This function is available when the Received Data Image Check Setting is enabled. * This is displayed when a facsimile expansion kit or Internet fax expansion kit is installed. If "Time Specified Output of Received Data" is set to , this setting is grayed out. If "Change Password" or "Hold Setting for Received Data Print" is set to , the password entry field is grayed out. Factory default settings: Disable 9-76