Sharp BP-70C45 Color Advanced and Essentials BP Series Operating Manual - Page 639

SCANNER/ INTERNET FAX►OTHER FUNCTIONS 5 Erase Left Up Right Down OK Clear Outer Frame Specify Frame+Center Reverse erase position of back face Tap the checkbox of the edge that you wish to erase, and specify the erase position. Check that the tapped checkbox is set to . If the [Outer Frame] key is tapped, the [Up], [Down], [Left],and [Right] checkboxes are set to . If the [Specify Frame+Center] key is tapped, all the checkboxes are set to . Specify the erase edge on the reverse side when erasing edges of one to three sides of Up, Down, Left, and Right on the front side to scan a 2-sided original. • If the [Reverse Erase Position of The Back Face] checkbox is set to erased edge on the front side will be erased. , the edge in the position opposite to the • If the [Reverse Erase Position of The Back Face] checkbox is set to side will be erased. , the edge in the same position as on the front • [Reverse Erase Position of The Back Face] is not possible when "Settings (administrator)" - [System Settings] → [Common Settings] → [Device Control] → [Condition Settings] or [Enable/Disable Settings] → [Disabling of Document Feeder] is enabled. 6 Specify the erase width. After the settings are completed, tap and [Back] keys in sequence. • Tap the numeric value display indicating the margin shift area on the front side or reverse side, and enter the area using the numeric keys. • To quickly set the area, first specify a value close to the desired value by the numeric keys, then adjust it with . To cancel the erase setting: Tap the [Clear] key. 7 Tap the [Start] key to start scanning of the original. • If you inserted the original pages in the document feeder tray, all pages are scanned. A beep will sound to indicate that scanning and transmission have ended. • When you place the original on the document glass, scan each page one at a time. When scanning finishes, place the next original and tap the [Start] key. Repeat until all pages have been scanned and then tap the [Read-End] key. A beep will sound to indicate that transmission has ended. You can tap the [Preview] key to check a preview of the image before sending an image. For more information, see "CHECKING THE IMAGE TO BE TRANSMITTED (page 6-93)" (When in fax mode, "CHECKING THE IMAGE TO BE TRANSMITTED (page 5-28)"). 6-133