Sharp BP-70C45 Color Advanced and Essentials BP Series Operating Manual - Page 833

SETTING MODE►SYSTEM SETTINGS Erase Width Adjustment This is used to set the default erase width for erase function. Specify a value from 0" (0 mm) to 1" (25 mm) in increments of 1/8" (3 mm) for both edge erase and center erase. Factory default settings: Edge Clearance Width:1/2" (10mm), Center Clearance Width 2:1/2" (10mm) Initial Multi Shot Setting Set the default state for Multi Shot. Select the page layout for Multi Shot, whether or not borders are added, and if added, whether the borders are solid lines or dotted lines. Factory default settings: Off, Layout:Left to Right/Right, and Down, Border:No Print Card Shot Settings This is used to set the default original size for the card shot function. Specify a value from 1" (25 mm) to 8-1/2" (216 mm) in increments of 1/8" (3 mm) for both the X (horizontal) and Y (vertical) dimensions of the original. Factory default settings: Original Size:X: 3-3/8" (86 mm), Y: 2-1/8" (54 mm) Fit to Page Enable this setting to have the [Fit to Page] key always appear in the card shot screen. Factory default settings: Disable Layout Select an image layout. Factory default settings: Set Vertically Automatic Saddle Stitch Set when saddle stitching is automatically stapled when binding is set. Factory default settings: Enable Initial Tab Copy Setting This is used to set the default image shift width (tab width) for tab copying. Specify a value from 0" (0 mm) to 1" (25 mm) in increments of 1/8" (3 mm). Factory default settings: Image Shift: 1/2" (10 mm) Disabling of Registration/Deletion of Program This is used to prohibit the deletion and changing of copy settings stored in job programs. Factory default settings: Disable 9-59