Sharp BP-70C45 Color Advanced and Essentials BP Series Operating Manual - Page 933
Services Settings
View all Sharp BP-70C45 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 933 highlights
SETTING MODE►SYSTEM SETTINGS Number of EAP Retries Set the number of times to re-access the EAP when communication fails. Factory default settings: 3 Time(s) Certificate Status Shows the status of the certificate required for transmission using IEEE802.1X. To install a certificate, click [Install]. CA Certificate Status Shows the status of the CA certificate required for transmission using IEEE802.1X. To install a certificate, click [Install]. Services Settings Make settings for SMTP, Kerberos Authentication Settings, SNTP, mDNS, SNMP, and SMB. When settings are changed, the changes will take effect after the machine is restarted. For details on restarting this machine, see "TURNING ON THE POWER (page 1-10)". SMTP SMTP Settings Primary Server Enter the IP address or the host name of the primary SMTP server. Secondary Server Enter the IP address or the host name of the secondary SMTP server. Port Number Enter a port number. Factory default settings: 25 Timeout Enter a timeout. This value is used for connection to the SMTP server and for data transmission according to the e-mail system specifications. Factory default settings: 20 seconds Sender Name Enter the sender name. Sender Address Enter the sender's address Enable SSL/TLS If the SSL is enabled, the SMTP-over-TLS encryption communication can be used by STARTTLS command. This requires the server to support the STARTTLS command. To allow SSL/TLS communication, set the "Port Number" to the same port number as the normal SMTP. Factory default settings: Disable SMTP Authentication Carries out the SMTP server authentication. If you use the Kerberos authentication, set the KDC server, port number, and realm on the Kerberos authentication settings page. Factory default settings: Disable 9-159