Sharp BP-70C45 Color Advanced and Essentials BP Series Operating Manual - Page 995

TROUBLESHOOTING►GENERAL PROBLEMS THE OUTPUT IS NOTICEABLY CURLED AND UNEVEN Check Remove the paper, turn it over, and reload it. Using a different paper type may solve the problem.  Solution ■ This may improve some states of paper curling. ► LOADING PAPER (page 1-11) THE IMAGE IS SKEWED ON THE PAPER Check  Solution Is too much paper loaded into the bypass tray? Are the bypass tray guides adjusted to the width of the paper? Are the original guides adjusted to the width of the paper? Is the control plate auxiliary block attached to the tray? (When using SRA3) Are you scanning originals of mixed width? (BP-50C26/BP-50C31/BP-50C36/ BP-50C45/BP-50C55/BP-50C65) ■ Reload the paper. Load no more than the maximum number of sheets and do not exceed the indicator line. The maximum number of sheets varies depending on the paper type setting. ■ Adjust the bypass tray guides to the width of the paper so that they slightly contact the sides of the paper. ■ Adjust the original guides to the width of the paper. ■ Attach the control plate auxiliary block. ■ If the printed image is skewed when you have scanned originals of mixed width, open the document feeder cover, change the switch position, and place the originals. The A position of the switch is for normal scanning. The B position is for scanning of mixed originals. Be sure to set the switch back to the A position after the mixed original job is finished. The original is scanned skewed. B A ■ Setting up a Easy Scan with automatic settings may solve the problem. 10-12