Sharp BP-70C45 Color Advanced and Essentials BP Series Operating Manual - Page 931

SETTING MODE►SYSTEM SETTINGS IPv4 Settings When using the machine on a TCP/IP (IPv4) network, use this setting to configure the IP address of the machine. The settings are shown below. DHCP Use this setting to have the IP address obtained utomatically using DHCP (Dynamic Host Configuration Protocol). When this setting is enabled, it is not necessary to manually enter an IP address. Factory default settings: Enable If DHCP/BOOTP is used, the IP address assigned to the machine may change automatically. If the IP address changes, printing will not be possible. IPv4 Address Enter the IP address of the machine. Subnet Mask Enter the IP subnet mask. Default Gateway Enter the default gateway address. IPv6 Settings When using the machine on a TCP/IP (IPv6) network, use this setting to configure the IP address of the achine. IPv6 Enable this setting. Factory default settings: Enable DHCPv6 Use this setting to have the IP address obtained automatically using DHCP (Dynamic Host Configuration Protocol) v6. When this setting is enabled, it is not necessary to manually enter an IP address. Factory default settings: Enable Manual Address/Prefix Length Enter the IP address and the prefix length (0 to 128) of the machine. Factory default settings: 0 Default Gateway Enter the default gateway. If DHCPv6 is used, the IP address assigned to the machine may change automatically. If the IP address changes, printing will not be possible. MTU Settings Set the maximum data size that can be forwarded. Factory default settings:1500 Ping Command Checks if the machine can communicate with the PC of the network. Specify the IP address of the desired PC and tap the [Execute] key. A message indicating a response by the PC or not is displayed. 9-157