Sharp BP-70C45 Color Advanced and Essentials BP Series Operating Manual - Page 428

FACSIMILE►BASIC TRANSMISSION METHODS Destination specified using the numeric keys With "Fax Dest. Confirmation Mode" enabled, and "Require Re-entry when Directly Entering the Fax Destination" enabled Tap the [Start] key to display the confirmation message. Tap the [OK] key, re-enter the destination using the numeric keys, and tap the [Enter Address] key. If the re-entered destination is correct, scanning will begin. If the re-entered destination is not correct, a message will appear. Tap the [OK] key and re-enter the destination. If an incorrect address is entered three times for confirmation, all the previous settings are canceled, and you will return to the base screen. With "Fax Dest. Confirmation Mode" enabled, and "Require Re-entry when Directly Entering the Fax Destination" disabled Tap the [Start] key to display entered destinations in the destination confirmation screen. Check that the destinations are correct, and tap the [Enter for send] key to start scanning of the original. • You can use the numeric keys to enter fax numbers serially. In that case, tap added. to enter the destination fax number to be • If the [Sub Address] key was tapped to enter a sub-address and passcode, the fax number must be re-entered during confirmation. After re-entering the fax number, tap the [Sub Address] key and enter the sub-address and passcode. • If chain dialing was used, tap the [Pause] key to enter "-" during confirmation. • Before tapping the [Enter for send] key, you can change scan or other settings. To set whether to re-enter at direct entry: In "Settings (administrator)", select [System Settings] → [Image Send Settings] → [Fax Settings] → [Condition Settings] → [Fax Dest. Confirmation Mode] → [Require Re-entry when Directly Entering the Fax Destination]. When a fax that was selected from the Sending History has been resent A confirmation screen is displayed based on the method used to specify the destination during the previous transmission. CHECKING THE IMAGE TO BE TRANSMITTED Check the image that will be sent in the touch panel before transmission. You can tap the [Preview] key and then scan the original to check a preview of the scanned image. As you can adjust the exposure and resolution to scan the original while checking it in the preview screen, you can send a better quality original to the destination. PREVIEW SCREEN (page 2-11) The settings and functions that can be changed while and after an image is scanned for preview are as follows: Exposure, Send Size, 2-Sided Booklet/Tablet, Resolution, Erase, N-Up, File, Quick File, Timer, Own Name Select, and Transaction Report. • Depending on the size of the transmission data, part of the preview image may not appear in the preview screen in the touch panel. • The preview function is not available when the original size is set to Long Size. 5-28