Brother International PE-DESIGN 10 Instruction Manual - Page 181
Hooping the fabric, Step 6
View all Brother International PE-DESIGN 10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 181 highlights
Tutorial 9-1: Creating Split Embroidery Designs 6 To mark an area below the previously marked area, align points A and B on the positioning sheet with marks C and D on the fabric. A B A B D C D C 7 Repeat steps 5 through 6 to reposition the positioning sheet and draw the embroidering position for each section of the embroidery pattern. a • The intersection of the horizontal and vertical line indicates the center of the embroidery hoop. • While carefully considering how the fabric will be hooped, place the positioning sheet on the fabric, and then draw lines to indicate the embroidering position. In addition, because all embroidery areas are not drawn on the positioning sheet for large embroidery hoops, be careful that the embroidery area does not extend from the marked area on the fabric as shown below. Step 6 Hooping the fabric 1 Insert the embroidery sheet into the inner ring of the embroidery hoop, and then place them on top of the fabric with the centerline on the embroidery sheet aligned with the reference lines (drawn on the fabric) for the first pattern section to be sewn. 2 Keeping the reference lines on the embroidery sheet aligned with the reference lines for the first pattern section, place the fabric and inner ring of the embroidery hoop into the outer ring of the hoop, and then pull the fabric so that it is tight. 3 Finish hooping the fabric, and then remove the embroidery sheet. Operations for Specific Applications 180