Brother International PE-DESIGN 10 Instruction Manual - Page 264
Using the edited fill/stamp, stitch patterns in Layout &, Editing
View all Brother International PE-DESIGN 10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 264 highlights
Creating Fill/Stamp Stitch Pattern Step 5 Using the edited fill/stamp stitch patterns in Layout & Editing 1 Start up Layout & Editing. 2 Select an embroidery pattern. 3 From the [Region sew type] selector (in the [Shapes] tab), select [Prog. Fill Stitch]. 4 Display the [Sewing Attributes] pane. cc "Specifying sewing attributes" on page 54 5 Click below [Programmable fill] in the [Region sew] section. 7 Click the edited fill/stamp stitch pattern, and then click [OK]. The pattern is applied to the inside regions of the embroidery pattern. b • A fill/stamp stitch pattern can also be applied as a stamp by using the Stamp Tools. cc "Applying and editing stamps" on page 58 • For best results, refer to "Notes on programmable fill stitches and stamps" on page 335. 6 Select the drive and folder where the pattern was saved in Step 4. 263