Brother International PE-DESIGN 10 Instruction Manual - Page 227
Handle Stage
View all Brother International PE-DESIGN 10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 227 highlights
Figure Handle Stage Changing settings for converting to outlines 1 In the Line Image Stage, click [To Figure Handle]. Figure Handle Stage ON Design Center cc "Line Image Stage" on page 213. 2 Specify the desired settings in the [Figure Object Conversion Setting] dialog box, and then click [OK]. a b c d e a Select a setting under [Resolution]. Fine Select this setting only if the image contains many small details. Normal Select this setting to provide a sufficient resolution without making the file too large. Coarse Select this setting to keep the file as small as possible. b To replace the black outlines with figure handle lines along the center of the outlines, select the [Thinning Process] check box, and then use the slider to select the degree of detail. b When the slider is set to [Much], even very thick black lines will be replaced with a line along the center. To replace the black lines with figure handle lines following the border of the outlines, clear the [Thinning Process] check box. OFF c Use the [SIZE] slider to set the size. d You will not be able to enlarge the image beyond the limits of the Design Page area. If necessary, click [Design Page Property], and then change the Design Page size. e To create outline data from a part of the image, select the specific area by clicking [Pick Area], then dragging the pointer (+) to draw a selection frame around the area to be selected. 226