Brother International PE-DESIGN Ver.6 Users Manual - English - Page 15
Installation
View all Brother International PE-DESIGN Ver.6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
PeDesignV6Eng.book Page 7 Thursday, July 8, 2004 11:59 AM Before Use Installation Installation procedure The installation procedure is different depending on whether the full version or an upgrade of the software is being installed. Be sure to perform the installation procedures listed below. Installing version 6.0 (full version) [STEP 1] Installing the software [STEP 2] Installing the driver for the card writer module Upgrading from version 1.0 through 4.0 [STEP 1] Installing the software [STEP 2] Installing the driver for the card writer module Upgrading from version 5.0 or 5.01 [STEP 1] Installing the software [STEP 2] Installing the driver for the card writer module [STEP 3] Upgrading the USB card writer module Upgrading from version 5.02 or later [STEP 1] Installing the software b Memo: When upgrading from version 5.02 or later, STEP 2 is not performed. [STEP 3] Upgrading the USB card writer module c page 8 c page 10 c page 8 c page 10 c page 8 c page 10 c page 12 c page 8 c page 12 a Note: • If the installation is interrupted or not performed as described, the software will not be installed correctly. • Before turning on the computer, be sure to disconnect the USB card writer module. If the computer is turned on while the card writer is connected, the installation may not be completed correctly when upgrading from version 5.0 or 5.01. • In order to upgrade the USB card writer module, you must be able to connect to the Internet. If you cannot connect to the Internet, contact your nearest service representative. 7