Brother International PE-DESIGN Ver.6 Users Manual - English - Page 221
Editing a Stitch Pattern in Fill/Stamp
View all Brother International PE-DESIGN Ver.6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 221 highlights
PeDesignV6Eng.book Page 213 Thursday, July 8, 2004 11:59 AM Programmable Stitch Creator 3. Click in the work area to specify the next point. 4. Continue clicking to specify every point, and then double-click the last point. Advanced Opreation Programmable Stitch Creator b Memo: To remove the last point that was entered, click the right mouse button. 5. Repeat the entire procedure until the fill/stamp stitch pattern is completed. Editing a Stitch Pattern in Fill/Stamp Mode Selecting patterns 1. Click on the Tool Box. → The shape of the pointer changes to . 2. Click the pattern that you want to select. → Handles appear around the pattern to show that it is selected. 3. To select an additional pattern, hold down the Ctrl key and click the other pattern. b Memo: • You can also select patterns by dragging the pointer across the pattern that you want to select. As you drag the pointer, a selection frame is drawn. All patterns that are contained in that selection frame are selected when the mouse button is released. • If you selected patterns that you did not want, click a blank area of the work area to deselect all patterns, and start again. a Note: A pattern will not be selected if you do not click one of its lines. b Memo: To deselect the pattern, select a different one, click a blank area of the work area, or click a button in the Tool Box other than . ■ Selecting all patterns 1. Make sure that on the Tool Box is selected. 2. Click Edit, then Select All. Moving patterns 1. Move the pointer over a selected pattern or group of selected patterns. → The shape of the pointer changes to . 213