Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 1001

track interface ipv6 routing c e s Configure object tracking on the routing status of an IPv6 Layer 3 interface. Syntax track object-id interface interface ipv6 routing To return to the default setting, enter no track object-id. Parameters object-id interface Enter the ID number of the tracked object. Range: 1 to 65535. Enter one of the following values: • For a 1-Gigabit Ethernet interface, enter gigabitethernet slot-number/ port-number. • For a Loopback interface, enter loopback number, where number is from 0 to 16383. • For a Port Channel interface, enter port-channel number, where the valid values are: C-Series and S-Series: 1 to 128 E-Series: 1 to 32 for EtherScale; 1 to 255 for TeraScale; 1 to 512 for ExaScale. • For SONET interfaces, enter the sonet slot-number/port-number. • For a 10-Gigabit Ethernet interface, enter tengigabitethernet slot-number/ port-number • For a VLAN interface, enter vlan number, where number is from 1 to 4094. Defaults None Command Modes CONFIGURATION Command History Related Commands Version 8.4.1.0 Introduced show track ipv6 route track interface ip routing Display information about tracked IPv6 routes, including configuration, current state, and clients which track the route. Configure object tracking on the routing status of an IPv4 Layer 3 interface. Usage Information Use this command to create an object that tracks the routing state of an IPv6 Layer 3 interface: • The status of the IPv6 interface is UP only if the Layer 2 status of the interface is UP and the interface has a valid IP address. • The Layer 3 status of an IPv6 interface goes DOWN when its Layer 2 status goes down (for a Layer 3 VLAN, all VLAN ports must be down) or the IP address is removed from the routing table. Object Tracking | 1001