Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 1179

47 Quality of Service (QoS) Overview FTOS commands for Quality of Service (QoS) include traffic conditioning and congestion control. QoS commands are not universally supported on all Dell Force10 platforms. Support is indicated by the c e and s characters under command headings. This chapter contains the following sections: • Global Configuration Commands • Per-Port QoS Commands • Policy-Based QoS Commands • Queue-Level Debugging (E-Series Only) Global Configuration Commands • qos-rate-adjust qos-rate-adjust c e s By default, while rate limiting, policing, and shaping, FTOS does not include the Preamble, SFD, or the IFG fields. These fields are overhead; only the fields from MAC Destination Address to the CRC are used for forwarding and are included in these rate metering calculations. You can optionally include overhead fields in rate metering calculations by enabling QoS Rate Adjustment. Syntax qos-rate-adjustment overhead-bytes Parameters overhead-bytes Include a specified number of bytes of packet overhead to include in rate limiting, policing, and shaping calculations. C-Series and S-Series Range: 1-31 E-Series Range: 1-144 Defaults QoS Rate Adjustment is disabled by default, and no qos-rate-adjust is listed in the running-configuration Command Modes CONFIGURATION Command History Version 8.3.1.0 Introduced Quality of Service (QoS) | 1179