Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 214

www.dell.com | support.dell.com Example Figure 9-4. Command Example: ip access-list standard FTOS(conf)#ip access-list standard TestList FTOS(config-std-nacl)# Related Commands ip access-list extended show config Create an extended access list. Display the current configuration. permit c e s Configure a filter to permit packets from a specific source IP address to leave the switch. Syntax permit {source [mask] | any | host ip-address} [count [byte] | log] [dscp value] [order] [monitor] To remove this filter, you have two choices: • Use the no seq sequence-number command syntax if you know the filter's sequence number or • Use the no permit {source [mask] | any | host ip-address} command. Parameters source mask any host ip-address count dscp byte log order monitor Enter the IP address in dotted decimal format of the network from which the packet was sent. (OPTIONAL) Enter a network mask in /prefix format (/x) or A.B.C.D. The mask, when specified in A.B.C.D format, may be either contiguous or non-contiguous. Enter the keyword any to specify that all routes are subject to the filter. Enter the keyword host followed by the IP address to specify a host IP address or hostname. (OPTIONAL) Enter the keyword count to count packets processed by the filter. (OPTIONAL) Enter the keyword dscp to match to the IP DSCP values. (OPTIONAL) Enter the keyword byte to count bytes processed by the filter. (OPTIONAL, E-Series only) Enter the keyword log to enter ACL matches in the log. (OPTIONAL) Enter the keyword order to specify the QoS priority for the ACL entry. Range: Default: 0-254 (where 0 is the highest priority and 254 is the lowest; lower order numbers have a higher priority) If the order keyword is not used, the ACLs have the lowest order by default (255). (OPTIONAL) Enter the keyword monitor when the rule is describing the traffic that you want to monitor and the ACL in which you are creating the rule will be applied to the monitored interface. For details, see the section "Flow-based Monitoring" in the Port Monitoring chapter of the FTOS Configuration Guide. Defaults Not configured. Command Modes CONFIGURATION-STANDARD-ACCESS-LIST 214 | Access Control Lists (ACL)