Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 400

www.dell.com | support.dell.com Command History Version 7.8.1.0 Version 7.7.1.0 Version 7.6.1.0 Introduced support on S-Series Introduced support on C-Series Introduced IPv6 MGBP support for E-Series distance bgp c et s Define an administrative distance for routes. Syntax distance bgp external-distance internal-distance local-distance To return to default values, enter no distance bgp. Parameters external-distance internal-distance local-distance Enter a number to assign to routes learned from a neighbor external to the AS. Range: 1 to 255. Default: 20 Enter a number to assign to routes learned from a router within the AS. Range: 1 to 255. Default: 200 Enter a number to assign to routes learned from networks listed in the network command. Range: 1 to 255. Default: 200 Defaults external-distance = 20; internal-distance = 200; local-distance = 200. Command Modes ROUTER BGP (conf-router_bgp_af) Caution: Dell Force10 recommends that you do not change the administrative distance of internal routes. Changing the administrative distances may cause routing table inconsistencies. Usage Information Command History The higher the administrative distance assigned to a route means that your confidence in that route is low. Routes assigned an administrative distance of 255 are not installed in the routing table. Routes from confederations are treated as internal BGP routes. Version 7.8.1.0 Version 7.7.1.0 Version 7.6.1.0 Introduced support on S-Series Introduced support on C-Series Introduced IPv6 MGBP support for E-Series neighbor activate c et s This command allows the specified neighbor/peer group to be enabled for the current AFI/SAFI. Syntax neighbor [ip-address | peer-group-name] activate To disable, use the no neighbor [ip-address | peer-group-name] activate command. 400 | Border Gateway Protocol IPv4 (BGPv4)