Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 1132

www.dell.com | support.dell.com ip pim ssm-range c e s Specify the SSM group range using an access-list. Syntax ip pim ssm-range {access_list_name} Parameters access_list_name Enter the name of the access list. Defaults Default SSM range is 232/8 and ff3x/32 Command Modes CONFIGURATION Command History Version 8.1.1.0 Version 7.8.1.0 Version 7.7.1.0 Version 7.5.1.0 Introduced on E-Series ExaScale Introduced on S-Series Introduced on C-Series. Introduced on E-Series. Usage Information FTOS supports standard access list for the SSM range. Extended ACL cannot be used for configuring SSM range. If an Extended ACL is configured and then used in the ip pim ssm-range {access list name} configuration, an error is reported. However, if ip pim ssm-range {access list name} is configured first and then the ACL is configured as an Extended ACL, an error is not reported and the ACL is not applied to the SSM range. FTOS recommended best-practices are to configure the standard ACL, and then apply the ACL to the SSM range. Once the SSM range is applied, the changes are applied internally without requiring clearing of the TIB. When ACL rules change, the ACL and PIM modules apply the new rules automatically. When SSM range is configured, FTOS supports SSM for configured group range as well as default SSM range. When the SSM ACL is removed, PIM SSM is supported for default SSM range only show ip pim ssm-range c e s Display the non-default groups added using the SSM range feature. Syntax show ip pim ssm-range Defaults No default behavior or values Command Modes EXEC EXEC Privilege Command History Version 8.1.1.0 Version 7.8.1.0 Introduced on E-Series ExaScale Introduced on S-Series 1132 | PIM-Source Specific Mode (PIM-SSM)