Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 1442

www.dell.com | support.dell.com Command Modes EXEC EXEC Privilege Command History Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.0 Support added for S-Series Support added for C-Series Introduced for E-Series Example Figure 59-6. show ntp associations Command Example FTOS#show ntp associations remote ref clock st when poll reach delay offset disp 10.10.120.5 0.0.0.0 16 - 256 0 0.00 0.000 16000.0 *172.16.1.33 127.127.1.0 11 6 16 377 -0.08 -1499.9 104.16 172.31.1.33 0.0.0.0 16 - 256 0 0.00 0.000 16000.0 192.200.0.2 0.0.0.0 16 - 256 0 0.00 0.000 16000.0 * master (synced), # master (unsynced), + selected, - candidate FTOS# Table 59-1. show ntp associations Command Fields Field (none) remote ref clock st when poll reach delay offset disp Description One or more of the following symbols could be displayed: • * means synchronized to this peer • # means almost synchronized to this peer • + means the peer was selected for possible synchronization • - means the peer is a candidate for selection • ~ means the peer is statically configured Displays the remote IP address of the NTP peer. Displays the IP address of the remote peer's reference clock. Displays the peer's stratum, that is, the number of hops away from the external time source. A 16 in this column means the NTP peer cannot reach the time source. Displays the last time the switch received an NTP packet. Displays the polling interval (in seconds). Displays the reachability to the peer (in octal bitstream). Displays the time interval or delay for a packet to complete a round-trip to the NTP time source (in milliseconds). Displays the relative time of the NTP peer's clock to the switch clock (in milliseconds). Displays the dispersion. Related Commands show ntp status Display current NTP status. show ntp status c e s Display the current NTP status. Syntax show ntp status 1442 | Time and Network Time Protocol (NTP)