Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 1547

reset linecard e Reset a specific line card module (power-off and then power-on). Syntax reset linecard slot-number Parameters slot-number Enter the slot number of the SFM to reset. Range: 0 to 6 Defaults No default values or behavior Command Modes EXEC Privilege Command History Version 6.5.4.0 Introduced Related Commands power on/off linecard Power on/off a line card reset sfm e Reset a specific SFM module (power-off and then power-on). Syntax reset sfm slot-number Parameters slot-number Enter the slot number of the SFM to reset. Range: 0 to 7 Defaults No default values or behavior Command Modes EXEC Privilege Command History Usage Information Version 6.5.4.0 Introduced When an error is detected on an SFM module, this command is a manual recovery mechanism. Since this command can be used with live traffic running, the switch fabric will not go down if the switch fabric is in an UP state. When there is a full set of SFMs online in the chassis, resetting one SFM will reduce the total bandwidth supported by the chassis and may affect data flow. A warning message is issued at the command line and requires user confirmation to proceed (Figure 65-7). Example Figure 65-7. reset sfm Command Example with Warning Message FTOS#reset sfm 0 SFM0 is active. Resetting it might temporarily impact data traffic. Proceed with reset [confirm yes/no]:yes Feb 16 00:39:30: %RPM1-P:CP %TSM-5-SFM_DISCOVERY: Found SFM 0 FTOS# This command does not permit resetting any SFM when the system has (max-1) SFM and switch fabric is up (Figure 65-8). E-Series Debugging and Diagnostics | 1547