Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 247
monitor, order
View all Dell Force10 S25N-S50N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 247 highlights
order monitor (OPTIONAL) Enter the keyword order to specify the QoS priority for the ACL entry. Range: 0 to 254 (where 0 is the highest priority and 254 is the lowest; lower order numbers have a higher priority) Default: If the order keyword is not used, the ACLs have the lowest order by default (255). (OPTIONAL) Enter the keyword monitor when the rule is describing the traffic that you want to monitor and the ACL in which you are creating the rule will be applied to the monitored interface. For details, see the section "Flow-based Monitoring" in the Port Monitoring chapter of the FTOS Configuration Guide. Defaults Not configured. Command Modes CONFIGURATION-EXTENDED-ACCESS-LIST Command History Version 8.2.1.0 Version 8.1.1.0 Version 7.4.1.0 Version 6.5.10 Allows ACL control of fragmented packets for IP (Layer 3) ACLs. Introduced on E-Series ExaScale Added monitor option Expanded to include the optional QoS order priority for the ACL entry. Usage The monitor option is relevant in the context of the flow-based monitoring feature only. See Information Chapter 44, Port Monitoring. When you use the log option, CP processor logs details about the packets that match. Depending on how many packets match the log entry and at what rate, the CP may become busy as it has to log these packets' details. The order option is relevant in the context of the Policy QoS feature only. The following applies: • The seq sequence-number is applicable only in an ACL group. • The order option works across ACL groups that have been applied on an interface via QoS policy framework. • The order option takes precedence over the seq sequence-number. • If sequence-number is not configured, then rules with the same order value are ordered according to their configuration order. • If the sequence-number is configured, then the sequence-number is used as a tie breaker for rules with the same order. Note: When ACL logging and byte counters are configured simultaneously, byte counters may display an incorrect value. Configure packet counters with logging instead. You cannot include IP, TCP or UDP (Layer 3) filters in an ACL configured with ARP or Ether-type (Layer 2) filters. Apply Layer 2 filters to interfaces in Layer 2 mode. Access Control Lists (ACL) | 247