Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 57

Defaults None. Command Mode EXEC Privilege Command History Version 7.7.1.0 Version 7.5.1.0 Renamed keyword primary-fpga-flash to fpga-image. Introduced on C-Series Example Command example: restore fpga-image FTOS#restore fpga-image linecard 4 Current FPGA information in the system Card FPGA Name Current Version New Version LC4 48 Port 1G LCM FPGA A: 3.6 restore * Warning - Upgrading FPGA is inherently risky and should * * only be attempted when necessary. A failure at this upgrade may * * cause a board RMA. Proceed with caution ! * Restore fpga image for linecard 4 [yes/no]: yes FPGA restore in progress. Please do NOT power off the card Upgrade result Linecard 4 FPGA restore successful. Usage Information Related Commands Reset the card using the power-cycle option after restoring the FPGA command. reset Reset a card. upgrade fpga-image c Upgrade the primary FPGA image. Syntax upgrade fpga-image {rpm {number | all}| linecard {number | all} [system-fpga | link-fpga] | all} {booted | file-url} Parameters rpm number linecard number all Enter rpm followed by the RPM slot number to upgrade an RPM FPGA Range: 0-1 Enter linecard followed by the line card slot number to upgrade a linecard FPGA. Range: 0-7 on the C300, 0-3 on the C150 Enter the keyword all to upgrade all RPM and linecard FPGAs. Enter the keyword all after the keyword rpm to upgrade all FPGAs on all RPMs. Enter the keyword all after the keyword linecard to upgrade all FPGAs on all linecards. File Management | 57