Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 364

www.dell.com | support.dell.com level-1-2 level-2 metric metric-value route-map map-name (OPTIONAL) Enter the keyword level-1-2 to independently redistributed into Level 1 and Level 2 routes. This is the default. (OPTIONAL) Enter the keyword level-2 to independently redistributed into Level 2 routes only (OPTIONAL) Enter the keyword metric followed by the metric value used for the redistributed route. Use a metric value that is consistent with the destination protocol. Range: 0 to 16777215 Default: 0 Enter the keyword route-map followed by the map name that is an identifier for a configured route map. The route map should filter imported routes from the source routing protocol to the current routing protocol. If you do not specify a map-name, all routes are redistributed. If you specify a keyword, but fail to list route map tags, no routes will be imported. Defaults level-1-2 Command Modes ROUTER BGP Example Figure 12-3. Command Example: redistribute isis (conf)#router bgp 1 (conf-router_bgp)#redistribute isis level-1 metric 44 route-map rmap-is2bgp (conf-router_bgp)#show running-config bgp ! router bgp 1 redistribute isis level-1 metric 44 route-map rmap-is2bgp Usage Information With FTOS version 8.3.1.0 and later, the redistribute command can be used to advertise the IGP cost as the MED on redistributed routes. When the route-map is set with metric-type internal and applied outbound to an EBGP peer/peer-group, the advertised routes corresponding to those peer/peer-group will have IGP cost set as MED. IS-IS to BGP redistribution supports matching of level-1 or level-2 routes or all routes (default). More advanced match options can be performed using route maps. The metric value of redistributed routes can be set by the redistribution command. Command History Version 8.3.1.0 Version 6.3.1.0 Introduced ability to substitute IGP cost for MED when a peer/peer-group outbound route-map is set as internal. Introduced redistribute ospf c e s Redistribute OSPF routes into BGP. Syntax redistribute ospf process-id [[match external {1 | 2}] [match internal]] [route-map map-name] To stop redistribution of OSPF routes, use the no redistribute ospf process-id command. 364 | Border Gateway Protocol IPv4 (BGPv4)