Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 491

Example 2 Figure 18-3. show frrp ring-id Command Example FTOS#show frrp 1 Ring protocol 1 is in Master mode Ring Protocol Interface: Primary : GigabitEthernet 0/16 State: Forwarding Secondary: Port-channel 100 State: Blocking Control Vlan: 1 Ring protocol Timers: Hello-Interval 50 msec Dead-Interval 150 msec Ring Master's MAC Address is 00:01:e8:13:a3:19 Topology Change Statistics: Tx:110 Rx:45 Hello Statistics: Tx:13028 Rx:12348 Number of state Changes: 34 Member Vlans: 1000-1009 FTOS# Example 3 Figure 18-4. show frrp ring-id summary Command Example FTOS#show frrp 2 summary Ring-ID State Mode Ctrl_Vlan Member_Vlans 2 Up Master 2 11-20, 25, 27-30 FTOS# Related Commands protocol frrp Enter the Resilient Ring Protocol and designate a ring identification timer c e Set the hello or dead interval for the Ring control packets. Syntax timer {hello-interval milliseconds}| {dead-interval milliseconds} To remove the timer, use the no timer {hello-interval [milliseconds]}| {dead-interval milliseconds} command. Parameters hello-interval milliseconds dead-interval milliseconds Enter the keyword hello-interval followed by the time, in milliseconds, to set the hello interval of the control packets. The milliseconds must be enter in increments of 50 milliseconds, for example 50, 100, 150 and so on. If an invalid value is enter, an error message is generated. Range: 50 to 2000ms Default: 500 ms Enter the keyword dead-interval followed by the time, in milliseconds, to set the dead interval of the control packets. Range: 50 to 6000ms Default: 1500ms Note: The configured dead interval should be at least three times the hello interval Defaults Default as shown Command Modes CONFIGURATION (conf-frrp) Command History Version 8.2.1.0 Version 7.4.1.0 Introduced for the C-Series Introduced FTOS Resilient Ring Protocol (FRRP) | 491