Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 1385

Table 55-1. Alarm Definitions Alarm Description lais Line Alarm Indication Signal lrdi Line Remote Defect Indication pais Path Alarm Indication Signal plop Path loss of Pointer prdi Path Remote Defect Indication sd-ber LBIP BER in excess of Signal Degradation threshold. The default SD alarm value is 10^-6, this value can not be changed. sf-ber LBIP BER in excess of Signal Failure threshold. The default SF alarm value is 10^-3, this value can not be changed. slof Section Loss of Frame slos Section Loss of Signal Related Commands show controllers Display alarms and defects clock source e Configure the clock source for each POS/SDH interface. Syntax clock source {internal | line} To return to the default setting, enter no clock source. Parameters internal line Enter the keyword internal to use the internal clock from the interface. Enter the keyword line to use the recovered clock from the interface. This is the default. Defaults line Command Modes INTERFACE debug ppp e Display traffic and information in a Point-to-Point Protocol (PPP) network. Syntax debug ppp [authentication | error | negotiation | packet] interface sonet slot/port To disable debugging, enter no debug ppp. SONET | 1385