Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 1239

Defaults No default behavior or values Command Modes ROUTER RIP Command History Version 7.8.1.0 Version 7.6.1.0 pre-7.7.1.0 Introduced on S-Series Introduced on C-Series Introduced on E-Series Related Commands router rip Enter ROUTER mode on the switch. distance c e s Assign a weight (for prioritization) to all routes in the RIP routing table or to a specific route. Lower weights ("administrative distance") are preferred. Syntax distance weight [ip-address mask [prefix-name]] To return to the default values, use the no distance weight [ip-address mask] command. Parameters weight ip-address mask prefix-name Enter a number from 1 to 255 for the weight (for prioritization). The default is 120. (OPTIONAL) Enter the IP address, in dotted decimal format (A.B.C.D), of the host or network to receive the new distance metric. If you enter an IP address, you must also enter a mask for that IP address, in either dotted decimal format or /prefix format (/x) (OPTIONAL) Enter a configured prefix list name. Defaults weight = 120 Command Modes ROUTER RIP Command History Related Commands Version 7.8.1.0 Version 7.6.1.0 pre-Version 6.2.1.1 default-metric Introduced on S-Series Introduced on C-Series Introduced on E-Series Assign one distance metric to all routes learned using the redistribute command. distribute-list in c e s Configure a filter for incoming routing updates. Syntax distribute-list prefix-list-name in [interface] To delete the filter, use the no distribute-list prefix-list-name in command. Router Information Protocol (RIP) | 1239