Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 616

www.dell.com | support.dell.com Example Figure 23-42. wanport Command with shutdown Command Example interface TenGigabitEthernet 13/0 no ip address no shutdown FTOS(conf-if-te-13/0)# FTOS(conf-if-te-13/0)#wanport % Error: Port should be in shutdown mode, config ignored Te 13/0. FTOS(conf-if-te-13/0)# FTOS(conf-if-te-13/0)#shutdown FTOS(conf-if-te-13/0)# FTOS(conf-if-te-13/0)#wanport FTOS(conf-if-te-13/0)# Related Commands ais-shut alarm-report clock source down-when-looped flag framing keepalive loopback Send LAIS on shutdown Enable reporting of a selected alarm Configure a clock source Send a message when a loopback condition is detected Set flags to ensure interoperability Set framing type Enable keepalive Troubleshoot a SONET loopback Port Channel Commands A Link Aggregation Group (LAG) is a group of links that appear to a MAC client as if they were a single link according to IEEE 802.3ad. In FTOS, a LAG is referred to as a Port Channel. Table 23-11. Port Channel Limits Platform Maximum Port Channel IDs Maximum Members per Port Channel E-Series ExaScale E-Series TeraScale E-Series EtherScale C-Series S-Series 255 64 255 16 32 16 128 8 128 8 Because each port can be assigned to only one Port Channel, and each Port Channel must have at least one port, some of those nominally available Port Channels might have no function because they could have no members if there are not enough ports installed. In the S-Series, those ports could be provided by stack members. The commands in this section are specific to Port Channel interfaces: • channel-member • group • interface port-channel • minimum-links • port-channel failover-group • show config 616 | Interfaces