Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 774
neighbor, subnet, timers, ROUTER BGP
View all Dell Force10 S25N-S50N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 774 highlights
www.dell.com | support.dell.com neighbor subnet c e Enable passive peering so that the members of the peer group are dynamic Syntax neighbor peer-group-name subnet subnet-number mask To remove passive peering, use the no neighbor peer-group-name subnet subnet-number mask command. Parameters subnet-number mask Enter a subnet number in dotted decimal format (A.B.C.D.) as the allowable range of addresses included in the Peer group. To allow all addresses, enter 0::0/0. Enter a prefix mask in / prefix-length format (/x). Defaults Not configured. Command Modes ROUTER BGP Command History Version 8.4.2.1 Version 8.2.1.0 Version 7.4.1.0 Introduced on C-Series and S4810. Introduced on E-Series ExaScale Introduced on E-Series TeraScale neighbor timers c e Set keepalive and hold time timers for a BGP neighbor or a peer group. Syntax neighbor {ipv6-address | peer-group-name} timers keepalive holdtime To return to the default values, use the no neighbor {ipv6-address | peer-group-name} timers command. Parameters ipv6-address peer-group-name keepalive holdtime Enter the IPv6 address in the x:x:x:x::x format. The :: notation specifies successive hexadecimal fields of zeros. Enter the name of the peer group to set the timers for all routers within the peer group. Enter a number for the time interval, in seconds, between keepalive messages sent to the neighbor routers. Range: 1 to 65535 Default: 60 seconds Enter a number for the time interval, in seconds, between the last keepalive message and declaring the router dead. Range: 3 to 65535 Default: 180 seconds Defaults keepalive = 60 seconds; holdtime = 180 seconds. Command Modes ROUTER BGP 774 | IPv6 Border Gateway Protocol (IPv6 BGP)