Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 678

www.dell.com | support.dell.com Table 24-16. show ip traffic output definitions Keyword ...no port broadcasts ...socket full Definition The incoming broadcast/multicast packet did not have any listener. The applications buffer was full and the incoming packet had to be dropped. Usage Information The F10 Monitoring MIB provides access to the statistics described below. Table 24-17. F10 Monitoring MIB Command Display IP statistics: Bcast: Received Sent Mcast: Received Sent ARP statistics: Rcvd: Request Replies Sent: Request Replies Proxy Object f10BcastPktRecv f10BcastPktSent f10McastPktRecv f10McastPktSent f10ArpReqRecv f10ArpReplyRecv f10ArpReqSent f10ArpReplySent f10ArpProxySent OIDs 1.3.6.1.4.1.6027.3.3.5.1.1 1.3.6.1.4.1.6027.3.3.5.1.2 1.3.6.1.4.1.6027.3.3.5.1.3 1.3.6.1.4.1.6027.3.3.5.1.4 1.3.6.1.4.1.6027.3.3.5.2.1 1.3.6.1.4.1.6027.3.3.5.2.3 1.3.6.1.4.1.6027.3.3.5.2.2 1.3.6.1.4.1.6027.3.3.5.2.4 1.3.6.1.4.1.6027.3.3.5.2.5 show protocol-termination-table e Display the IP Packet Termination Table (IPPTT). Syntax show protocol-termination-table linecard number port-set port-pipe-number Parameters linecard number port-set port-pipe-number Enter the keyword linecard followed by slot number of the line card. E-Series Range: 0 to 13 on a E1200/1200i, 0 to 6 on a E600/E600i, and 0 to 5 on a E300 Enter the keyword port-set followed by the line card's Port-Pipe number. Range: 0 to 1 Defaults No default behavior or values Command Modes EXEC EXEC Privilege 678 | IPv4 Routing