Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 520

www.dell.com | support.dell.com Parameters test-condition statistic operator number value cpu | rpm-any Enter the keyword test-condition, followed by one of the following statistic request types: cpu-1-min: Average CPU utilization for 1 minute cpu-5-min: Average CPU utilization for 5 minutes interface-bit-rate {input | output} slot#: Instantaneous bit rate on a given line card interface-crc interface: Number of CRC errors on a given interface interface-rate interface: Packet rate on a given interface interface-throttles interface: Number of throttles on an interface memory-free: Free system memory memory-free-percent: Free system memory free in percentage memory-used: System memory used memory-used-percent: System memory used in percentage wred-drops interface: Number of WRED drops on an interface (E-Series only) Enter one of the following Boolean comparison operators: decrease, equal-to, greater-than, increase, less-than, not-equal-to, no-change. Enter the keyword number, followed by an integer to be the comparison value to the designated statistic, in the range pertinent to the statistic. Enter the processor that will be tested: cp, lp, rp1, rp2, or test all RPM CPUs with the keyword rpm-any. Defaults None Command Mode CALL-HOME TEST-LIST Command History Version 8.2.1.0 Version 7.8.1.0 Removed message-text keyword. Added operators. Introduced on C-Series and E-Series Usage Information FTOS does not allow you to configure a test that makes no sense, such as cpu-5-min greater-than number 150. CPU percentage utilization can only go up to 100, so 150 is not possible. FTOS displays the acceptable range, as shown below Examples FTOS(conf-callhome-testlist-test)#test-condition cpu-5-min greater-than ? number The boolean comparison value FTOS(conf-callhome-testlist-test)#test-condition cpu-5-min greater-than number ? Enter the boolean comparison value FTOS(conf-callhome-testlist-test)#test-condition cpu-5-min greater-than number 10 This example shows a couple other keyword configuration examples. FTOS(conf-call-home-testlist-test)# test-condition interface-rate input 1 less-than number 98 FTOS(conf-call-home-testlist-test)# test-condition memory-used not-equal-to number 1000 Related Commands dampen test-limit Set a delay before sampling for a test condition again after it has been matched. Set the number of times that the test list that should be executed. 520 | FTOS Service Agent