Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 1184
service-class dynamic dot1p, dot1p, E-Series, Queue ID
View all Dell Force10 S25N-S50N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1184 highlights
www.dell.com | support.dell.com Related Commands rate-shape Shape traffic output as part of the designated policy. service-class dynamic dot1p c e s Honor all 802.1p markings on incoming switched traffic on an interface (from INTERFACE mode) or on all interfaces (from CONFIGURATION mode). A CONFIGURATION mode entry supersedes INTERFACE mode entries. Syntax service-class dynamic dot1p To return to the default setting, enter no service-class dynamic dot1p. Defaults All dot1p traffic is mapped to Queue 0 unless service-class dynamic dot1p is enabled. Then the default mapping is as follows: Table 47-1. Default dot1p to Queue Mapping dot1p 0 1 2 3 4 5 6 7 E-Series Queue ID 2 0 1 3 4 5 6 7 C-Series Queue ID 1 0 0 1 2 2 3 3 S-Series Queue ID 1 0 0 1 2 2 3 3 Command Modes INTERFACE CONFIGURATION (C-Series and S-Series only) Command History Version 8.2.1.0 Version 7.6.1.0 Version 7.5.1.0 Version 6.5.1.0 pre-Version 6.1.1.1 Available globally on the C-Series and S-Series so that the configuration applies to all ports. Introduced on S-Series Introduced on C-Series Expanded command to permit configuration on port channels Introduced on E-Series Usage Information Enter this command to honor all incoming 802.1p markings, on incoming switched traffic, on the interface. By default, this facility is not enabled (that is, the 802.1p markings on incoming traffic are not honored). This command can be applied on both physical interfaces and port channels. When you set the service-class dynamic for a port channel, the physical interfaces assigned to the port channel are automatically configured; you cannot assign the service-class dynamic command to individual interfaces in a port channel. 1184 | Quality of Service (QoS)