Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 61

Figure 4-1. First Field in the boot change Command BOOT_USER # boot change primary '.' = clear field; '-' = clear non-essential field boot device : ftp Figure 4-2 shows the completed command: Figure 4-2. Completed boot change Command Example BOOT_USER # boot change primary '.' = clear field; '-' = go to previous field boot device file name Server IP address username password : ftp : tt/latestlabel : 10.16.1.209 : amsterdam : ****** BOOT_USER # In the runtime CLI of C-Series and E-Series, use the boot system command to change the boot image file and location. To view the current boot configuration, use the show bootvar command. Related Commands boot system boot zero show boot selection show bootvar Set the location of FTOS image files. Remove the primary, secondary, or default boot image configuration. Display the current Boot Flash image selected. Display boot configuration information. boot messages c e Limit the number of messages seen during system boot-up. Syntax boot messages {disable | enable} Parameters disable enable Enter the keyword disable to display fewer messages during boot-up. Enter the keyword enable to display all messages during boot-up. Defaults enable (that is, all messages are displayed during boot up) Command Modes BOOT_USER boot selection c e Specify the boot flash partition in the internal Flash from which to boot the system. Syntax boot selection [a | b] BOOT_USER Mode | 61