Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 549
ip igmp last-member-query-interval, ip igmp querier-timeout
View all Dell Force10 S25N-S50N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 549 highlights
ip igmp last-member-query-interval c e s Change the last member query interval, which is the Max Response Time inserted into Group-Specific Queries sent in response to Leave Group messages. This interval is also the interval between Group-Specific Query messages. Syntax ip igmp last-member-query-interval milliseconds To return to the default value, enter no ip igmp last-member-query-interval. Parameters milliseconds Enter the number of milliseconds as the interval. Default: 1000 milliseconds Range: 100 to 65535 Defaults 1000 milliseconds Command Modes INTERFACE Command History Version 7.8.1.0 Introduced on S-Series Version 7.7.1.0 Introduced on C-Series E-Series legacy command ip igmp querier-timeout c e s Change the interval that must pass before a multicast router decides that there is no longer another multicast router that should be the querier. Syntax ip igmp querier-timeout seconds To return to the default value, enter no ip igmp querier-timeout. Parameters seconds Enter the number of seconds the router must wait to become the new querier. Default: 125 seconds Range: 60 to 300 Defaults 125 seconds Command Modes INTERFACE Command History Version 7.8.1.0 Introduced on S-Series Version 7.7.1.0 Introduced on C-Series Version 7.6.1.0 Introduced on S-Series in Interface VLAN mode only to enable that system to act as an IGMP Proxy Querier. Version 7.5.1.0 Introduced on C-Series in Interface VLAN mode only to enable that system to act as an IGMP Proxy Querier. E-Series legacy command Internet Group Management Protocol (IGMP) | 549