Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 1244
network, offset-list
View all Dell Force10 S25N-S50N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1244 highlights
www.dell.com | support.dell.com Command History Version 7.8.1.0 Version 7.6.1.0 pre-Version 6.2.1.1 Introduced on S-Series Introduced on C-Series Introduced on E-Series Usage When a neighbor router is identified, unicast data exchanges occur. Multiple neighbor routers are Information possible. Use the passive-interface command in conjunction with the neighbor command to ensure that only specific interfaces are receiving and sending data. Related Commands passive-interface Sets the interface to only listen to RIP broadcasts. network c e s Enable RIP for a specified network. Use this command to enable RIP on all networks connected to the switch. Syntax network ip-address To disable RIP for a network, use the no network ip-address command. Parameter ip-address Specify an IP network address in dotted decimal format. You cannot specify a subnet. Defaults No RIP network is configured. Command Modes ROUTER RIP Command History Version 7.8.1.0 Version 7.6.1.0 pre-Version 6.2.1.1 Introduced on S-Series Introduced on C-Series Introduced on E-Series Usage Information You can enable an unlimited number of RIP networks. RIP operates over interfaces configured with any address specified by the network command. offset-list c e s Specify a number to add to the incoming or outgoing route metrics learned via RIP. Syntax Parameters offset-list prefix-list-name {in | out} offset [interface] To delete an offset list, use the no offset-list prefix-list-name {in | out} offset [interface] command. prefix-list-name Enter the name of an established Prefix list to determine which incoming routes will be modified. 1244 | Router Information Protocol (RIP)