Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 1102

www.dell.com | support.dell.com restart-time stale-entry-time (OPTIONAL) Enter the keyword restart-time followed by the number of seconds estimated for the PIM speaker to restart. Range: 30 to 300 seconds Default: 180 seconds (OPTIONAL) Enter the keyword stale-entry-time followed by the number of seconds for which entries are kept alive after restart. Range: 30 to 300 seconds Default: 60 seconds Defaults as above Command Modes CONFIGURATION Command History Version 8.2.1.0 Version 7.6.1.0 Introduced on E-Series ExaScale. Added the ipv6 option for E-Series. Introduced on E-Series Usage Information When an NSF-capable router comes up, it announces the graceful restart capability and restart duration as a Hello option. The receiving router notes the Hello option. Routers not NSF capable will discard the unknown Hello option and adjacency is not affected. When an NSF-capable router goes down, neighboring PIM speaker preserves the states and continues the forwarding of multicast traffic while the neighbor router restarts. ip pim join-filter c e s Permit or deny PIM Join/Prune messages on an interface using an extended IP access list. This command prevents the PIM SM router from creating state based on multicast source and/or group. Syntax ip pim join-filter ext-access-list {in | out} Remove the access list using the command no ip pim join-filter ext-access-list {in | out} Parameters ext-access-list in out Enter the name of an extended access list. Enter this keyword to apply the access list to inbound traffic. Enter this keyword to apply the access list to outbound traffic. Defaults None Command Modes INTERFACE Command History Version 8.1.1.0 Version 7.8.1.0 Version 7.7.1.0 Introduced on E-Series ExaScale Introduced on C-Series on port-channels and S-Series Introduced on E-Series. 1102 | PIM-Sparse Mode (PIM-SM)