Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 756

www.dell.com | support.dell.com Command Modes EXEC Privilege Usage This command turns on BGP soft-reconfiguration inbound debugging for IPv6 unicast routes. If no Information neighbor is specified, debug is turned on for all neighbors. Command History Version 8.4.1.0 Version 7.8.1.0 Version 7.7.1.0 Version 7.2.1.0 Added support for IPv4 multicast and IPv6 unicast routes Introduced support on S4810 Introduced support on C-Series Introduced on the E-Series TeraScale debug ip bgp keepalives c e Allows you to view information about BGP keepalive messages. Syntax debug ip bgp [ipv6-address | peer-group peer-group-name] keepalives [in | out] To disable debugging, use the no debug ip bgp [ip-address | peer-group peer-group-name] keepalives [in | out] command. Parameters ipv6-address peer-group peer-group-name in out (OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format followed by the prefix length in the /x format. Range: /0 to /128 The :: notation specifies successive hexadecimal fields of zeros. (OPTIONAL) Enter the keyword peer-group followed by the name of the peer group. (OPTIONAL) Enter the keyword in to view only inbound keepalive messages. (OPTIONAL) Enter the keyword out to view only outbound keepalive messages. Command Modes EXEC Privilege Command History Version 8.4.2.1 Version 8.2.1.0 Version 7.4.1.0 Introduced on C-Series and S4810. Introduced on E-Series ExaScale Introduced on E-Series TeraScale Usage Enter the no debug ip bgp command to remove all configured debug commands for BGP. Information debug ip bgp notifications c e Allows you to view information about BGP notifications received from neighbors. Syntax debug ip bgp [ipv6-address | peer-group peer-group-name] notifications [in | out] 756 | IPv6 Border Gateway Protocol (IPv6 BGP)