Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 779

Parameters level-1 | level-1-2 | level-2] metric metric-type route-map map-name (OPTIONAL) Enter the type (level) of routes to redistribute. (OPTIONAL) Assign metric to an interface for use with IPv6 information (OPTIONAL) The external link type associated with the default route advertised into a routing domain. You must specify one of the following: • external • internal (Default) (OPTIONAL) Enter the keyword route-map followed by the name of an established route map. Only the following ROUTE-MAP mode commands are supported: • match ipv6 address • match ipv6 next-hop • match ipv6 route-source • set ipv6 next-hop If the route map is not configured, the default is deny (to drop all routes). Defaults Not configured. Command Modes ROUTER BGPV6-ADDRESS FAMILY Command History Version 8.4.2.1 Version 8.2.1.0 Version 7.4.1.0 Introduced on C-Series and S4810. Introduced on E-Series ExaScale Introduced on E-Series TeraScale redistribute ospf c e Redistribute OSPFv3 routes into BGP. Syntax redistribute ospf process-id [[match external {1 | 2}] [match internal]] [route-map map-name] To stop redistribution of OSPF routes, use the no redistribute ospf process-id command. Parameters process-id match external {1 | 2} match internal route-map map-name Enter the number of the OSPFv3 process. Range: 1 to 65535 (OPTIONAL) Enter the keywords match external to redistribute OSPF external routes. You can specify 1 or 2 to redistribute those routes only. (OPTIONAL) Enter the keywords match internal to redistribute OSPFv3 internal routes only. (OPTIONAL) Enter the keyword route-map followed by the name of an established route map. Only the following ROUTE-MAP mode commands are supported: • match ipv6 address • match ipv6 next-hop • match ipv6 route-source • set ipv6 next-hop If the route map is not configured, the default is deny (to drop all routes). IPv6 Border Gateway Protocol (IPv6 BGP) | 779