Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 1251

Command History Version 7.8.1.0 Version 7.7.1.0 Version 7.6.1.0 Introduced on S-Series Introduced on C-Series Introduced on E-Series timers basic c e s Manipulate the RIP timers for routing updates, invalid, holddown times and flush time. Syntax timers basic update invalid holddown flush To return to the default settings, enter no timers basic. Parameters update invalid holddown flush Enter the number of seconds to specify the rate at which RIP routing updates are sent. Range: zero (0) to 4294967295. Default: 30 seconds. Enter the number of seconds to specify the time interval before routing updates are declared invalid or expired. The invalid value should be at least three times the update timer value. Range: zero (0) to 4294967295. Default: 180 seconds. Enter the number of seconds to specify a time interval during which the route is marked as unreachable but still sending RIP packets. The holddown value should be at least three times the update timer value. Range: zero (0) to 4294967295. Default: 180 seconds. Enter the number of seconds to specify the time interval during which the route is advertised as unreachable. When this interval expires, the route is flushed from the routing table. The flush value should be greater than the update value. Range: zero (0) to 4294967295. Default is 240 seconds. Defaults update = 30 seconds; invalid = 180 seconds; holddown = 180 seconds; flush = 240 seconds. Command Modes ROUTER RIP Command History Version 7.8.1.0 Version 7.6.1.0 pre-Version 6.2.1.1 Introduced on S-Series Introduced on C-Series Introduced on E-Series Usage If the timers on one router are changed, the timers on all routers in the RIP domain must also be Information synchronized. Router Information Protocol (RIP) | 1251