Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 194

www.dell.com | support.dell.com dot1x host-mode c e ts Enable single-host or multi-host authentication. Syntax Parameters dot1x host-mode {single-host | multi-host | multi-auth} single-host multi-host multi-auth Enable single-host authentication. Enable multi-host authentication. Enable multi-supplicant authentication. Defaults single-host Command Modes INTERFACE Command History Version 8.4.1.0 Version 8.3.2.0 The multi-auth option was introduced on the C-Series and S-Series. The single-host and multi-host options were introduced on the C-Series, E-Series TeraScale, and S-Series Usage Information Related Commands • Single-host mode authenticates only one host per authenticator port, and drops all other traffic on the port. • Multi-host mode authenticates the first host to respond to an Identity Request, and then permits all other traffic on the port. • Multi-supplicant mode authenticates every device attempting to connect to the network on through the authenticator port. show dot1x interface dot1x mac-auth-bypass c s Enable MAC authentication bypass. If 802.1X times out because the host did not respond to the Identity Request frame, FTOS attempts to authenticate the host based on its MAC address. Syntax dot1x mac-auth-bypass Defaults Disabled Command Modes INTERFACE Command History Version 8.4.1.0 Introduced on C-Series and S-Series Usage To disable MAC authentication bypass on a port, enter the no dot1x mac-auth-bypass command. Information Related Commands dot1x auth-type mab-only 194 | 802.1X