Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 260

www.dell.com | support.dell.com Command Modes CONFIGURATION Command History Version 8.1.1.0 Version 7.8.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.0 Introduced on E-Series ExaScale Increased name string to accept up to 140 characters. Prior to 7.8.1.0, names are up to 16 characters long. Support added for S-Series Support added for C-Series Introduced for E-Series Usage The number of entries allowed per ACL is hardware-dependent. Refer to your line card documentation Information for detailed specification on entries allowed per ACL. Prior to 7.8.1.0, names are up to 16 characters long. Example Figure 9-8. Command Example: mac-access-list extended FTOS(conf)#mac-access-list access-list extended TestMATExt FTOS(config-ext-macl)#remark 5 IPv4 FTOS(config-ext-macl)#seq 10 permit any any ev2 eq 800 count bytes FTOS(config-ext-macl)#remark 15 ARP FTOS(config-ext-macl)#seq 20 permit any any ev2 eq 806 count bytes FTOS(config-ext-macl)#remark 25 IPv6 FTOS(config-ext-macl)#seq 30 permit any any ev2 eq 86dd count bytes FTOS(config-ext-macl)#seq 40 permit any any count bytes FTOS(config-ext-macl)#exit FTOS(conf)#do show mac accounting access-list snickers interface g0/47 in Extended mac access-list snickers on GigabitEthernet 0/47 seq 10 permit any any ev2 eq 800 count bytes (559851886 packets 191402152148 bytes) seq 20 permit any any ev2 eq 806 count bytes (74481486 packets 5031686754 bytes) seq 30 permit any any ev2 eq 86dd count bytes (7751519 packets 797843521 bytes) Related Commands mac access-list standard show mac accounting access-list Configure a standard MAC access list. Display MAC access list configurations and counters (if configured). permit c e s Configure a filter to pass packets matching the criteria specified. Syntax permit {any | host mac-address | mac-source-address mac-source-address-mask} {any | host mac-address | mac-destination-address mac-destination-address-mask} [ethertype operator] [count [byte]] | [log] [monitor] To remove this filter, you have two choices: • Use the no seq sequence-number command syntax if you know the filter's sequence number or • Use the no permit {any | host mac-address | mac-source-address mac-source-address-mask} {any | mac-destination-address mac-destination-address-mask} command. 260 | Access Control Lists (ACL)