Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 513

run-cpu c e Set whether the action list associated with the selected test list should be executed, as a function of CPU utilization. Syntax run-cpu {cpu | rpm-any} {less-than | greater-than} percentage Parameters percentage cpu rpm-any Enter a CPU utilization percentage. Range: 0-100 Select a CPU: CP, LP, RP1, or RP2 Monitor all RPM CPUs for the run-cpu condition (CP, RP1, and RP2) Default None Command Mode CALL-HOME POLICY Command History Version 8.2.1.0 Version 7.8.1.0 Added variable cpu, and keyword rpm-any. Keyword more-than changed to greater-than. Keyword unconditional removed. Introduced on C-Series and E-Series Usage The purpose of this command is to determine whether the action list associated with this test list should be executed, depending on whether the CPU utilization at the time the test list is executed meets the configured parameter: Related Commands • If less-than is configured, the user might be worried about executing the action list in high CPU usage conditions. In such a case, for example, the user might configure run-cpu less-than 90. When a match is made to the test list, the CPU 1-minute average is checked and if it is 85%, for example, then the associated action list will be executed. If the current CPU usage is at 90% or greater, the action list will not be executed. In this case, FTSA logs this in the syslog to note that a match was made, what the match was, and that the action list was not executed because CPU was too high. • If greater-than is configured, it is probably because the user does not care about results that may occur when CPU usage is low. For example, a user might configure run-cpu greater-than 60. If a match is found for the test list and the 1-minute CPU average is 40%, then the action list is not executed; if it is 61% or greater, then it is executed. policy Create a policy with a name and enter config-callhome-policy-name mode. sample-rate c e Set the sampling interval for how often to execute the configured test condition. Syntax sample-rate number Parameters number Set the sampling interval for how often to execute the configured test condition. Range: 1-1440 (minutes) Default 1 (one minute) FTOS Service Agent | 513