Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 91

Defaults The IP address on the system that is closest to the Telnet address is used in the outgoing packets. Command Modes CONFIGURATION Command History Version 8.2.1.0 Increased number of VLANs on ExaScale to 4094 (was 2094) Version 8.1.1.0 Introduced on E-Series ExaScale Version 7.6.1.0 Support added for S-Series Version 7.5.1.0 Introduced on C-Series E-Series original Command Related Commands telnet Telnet to another device. ip tftp source-interface c e s Assign an interface's IP address in outgoing packets for TFTP traffic. Syntax ip tftp source-interface interface Parameters interface Enter the following keywords and slot/port or number information: • For an 100/1000 Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For Loopback interfaces, enter the keyword loopback followed by a number from zero (0) to 16383. • For a Port Channel, enter the keyword port-channel followed by a number: C-Series and S-Series: 1-128 E-Series: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for ExaScale • For the SONET interfaces, enter the keyword sonet followed by slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a VLAN interface, enter the keyword vlan followed by a number from 1 to 4094. Defaults The IP address on the system that is closest to the Telnet address is used in the outgoing packets. Command Modes CONFIGURATION Command History Version 8.2.1.0 Increased number of VLANs on ExaScale to 4094 (was 2094) Version 8.1.1.0 Introduced on E-Series ExaScale Version 7.6.1.0 Support added for S-Series Version 7.5.1.0 Introduced on C-Series E-Series original Command Control and Monitoring | 91