Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 332

www.dell.com | support.dell.com Command History Version 7.8.1.0 Version 7.7.1.0 Introduced support on S-Series Introduced support on C-Series bgp soft-reconfig-backup c e s Use this command only when route-refresh is not negotiated between peers to avoid having a peer resend BGP updates. Syntax bgp soft-reconfig-backup To return to the default setting, use the no bgp soft-reconfig-backup command. Defaults Off Command Modes ROUTER BGP Usage Information When soft-reconfiguration is enabled for a neighbor and the clear ip bgp soft in is executed, the update database stored in the router is replayed and updates are reevaluated. With this command, the replay and update process is triggered only if route-refresh request is not negotiated with the peer. If the request is indeed negotiated (upon execution of clear ip bgp soft in), then BGP sends a route-refresh request to the neighbor and receives all of the peer's updates. Related Commands clear ip bgp ipv4 unicast soft Activate inbound policies for IPv4 routes without resetting the BGP TCP in session. Command History Version 8.4.1.0 Version 7.8.1.0 Version 7.7.1.0 Version 7.2.1.0 Added support for IPv4 multicast and IPv6 unicast address families Introduced support on S-Series Introduced support on C-Series Introduced capture bgp-pdu neighbor c e s Enable capture of an IPv4 BGP neighbor packet. Syntax capture bgp-pdu neighbor ipv4-address direction {both | rx | tx} To disable capture of the IPv4 BGP neighbor packet, use the no capture bgp-pdu neighbor ipv4-address command. Parameters ipv4-address direction {both | rx | tx} Enter the IPv4 address of the target BGP neighbor. Enter the keyword direction and a direction- either rx for inbound, tx for outbound, or both. Defaults Not configured. Command Modes EXEC Privilege 332 | Border Gateway Protocol IPv4 (BGPv4)