Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 778

www.dell.com | support.dell.com Usage Though FTOS does not generate a route due to backdoor config, there is an option for injecting/ Information sourcing a local route in presence of network backdoor config on a learned route. redistribute c e Redistribute routes into BGP. Syntax redistribute {connected | static} [route-map map-name] To disable redistribution, use the no redistribution {connected | static} command. Parameters connected static route-map map-name Enter the keyword connected to redistribute routes from physically connected interfaces. Enter the keyword static to redistribute manually configured routes. These routes are treated as incomplete routes. (OPTIONAL) Enter the keyword route-map followed by the name of an established route map. Only the following ROUTE-MAP mode commands are supported: • match ipv6 address • match ipv6 next-hop • match ipv6 route-source • set ipv6 next-hop If the route map is not configured, the default is deny (to drop all routes). Defaults Not configured. Command Modes ROUTER BGPV6-ADDRESS FAMILY Command History Version 8.4.2.1 Version 8.2.1.0 Version 7.4.1.0 Introduced on C-Series and S4810. Introduced on E-Series ExaScale Introduced on E-Series TeraScale Usage If you do not configure default-metric command, in addition to the redistribute command, or there is no Information route map to set the metric, the metric for redistributed static and connected is "0". To redistribute the default route (0::0/0) configure the neighbor default-originate command. Related Commands neighbor default-originate Inject the default route. redistribute isis c e Redistribute IS-IS routes into BGP. Syntax redistribute isis [level-1 | level-1-2 | level-2] [metric metric-value | metric-type {external | internal}] [route-map map-name] To stop redistribution of IS-IS routes, use the no redistribute isis command. 778 | IPv6 Border Gateway Protocol (IPv6 BGP)