Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 1105

ip pim rp-address c e s Configure a static PIM Rendezvous Point (RP) address for a group or access-list. Syntax ip pim rp-address address {group-address group-address mask} override To remove an RP address, use the no ip pim rp-address address {group-address group-address mask} override command. Parameters address group-address group-address mask override Enter the RP address in dotted decimal format (A.B.C.D). Enter the keyword group-address followed by a group-address mask, in dotted decimal format (/xx), to assign that group address to the RP. Enter the keyword override to override the BSR updates with static RP. The override will take effect immediately during enable/disable. Note: This option is applicable to multicast group range. Defaults Not configured Command Modes CONFIGURATION Command History Version 8.1.1.0 Version 7.8.1.0 pre-Version 6.1.1.1 Introduced on E-Series ExaScale Introduced on S-Series Introduced on E-Series Usage Information This address is used by first-hop routers to send Register packets on behalf of source multicast hosts. The RP addresses are stored in the order in which they are entered. RP addresses learned via BSR take priority over static RP addresses. Without the override option, RPs advertised by the BSR updates take precedence over the statically configured RPs. PIM-Sparse Mode (PIM-SM) | 1105