Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 90

www.dell.com | support.dell.com Version 7.5.1.0 Introduced on C-Series E-Series original Command Usage You must also configure a password with the ip ftp password command. Information Related Commands ip ftp password Set the password for FTP connections. ip telnet server enable c e s Enable the Telnet server on the switch. Syntax ip telnet server enable To disable the Telnet server, execute the no ip telnet server enable command. Defaults Enabled Command Modes CONFIGURATION Command History Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 Version 6.1.1.0 Introduced on E-Series ExaScale Support added for S-Series Introduced on C-Series Introduced on E-Series Related Commands ip ssh server Enable SSH server on the system. ip telnet source-interface c e s Set an interface's IP address as the source address in outgoing packets for Telnet sessions. Syntax ip telnet source-interface interface Parameters interface Enter the following keywords and slot/port or number information: • For an 100/1000 Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For Loopback interfaces, enter the keyword loopback followed by a number from zero (0) to 16383. • For the SONET interfaces, enter the keyword sonet followed by slot/port information. • For a Port Channel, enter the keyword port-channel followed by a number: C-Series and S-Series: 1-128 E-Series: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for ExaScale • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For VLAN interface, enter the keyword vlan followed by a number from 1 to 4094. 90 | Control and Monitoring