Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 1208

www.dell.com | support.dell.com Version 7.4.1.0 pre-Version 6.1.1.1 E-Series Only: Expanded to add support for mac-dot1p Introduced on E-Series Usage Information C-Series and S-Series Once the IP DSCP bit is set, other QoS services can then operate on the bit settings. E-Series Once the IP DSCP bit is set, other QoS services can then operate on the bit settings. WRED (Weighted Random Early Detection) ensures that high-precedence traffic has lower loss rates than other traffic during times of congestion. show cam layer2-qos e Display the Layer 2 QoS CAM entries. Syntax show cam layer2-qos {[linecard number port-set number] | [interface interface]} [summary] Parameters linecard number port-set number interface interface summary Enter the keyword linecard followed by the line card slot number. E-Series Range: 0 to 13 on a E1200, 0 to 6 on a E600/E600i, and 0 to 5 on a E300. Enter the keyword port-set followed by the line card's port pipe. Range: 0 or 1 Enter the keyword interface followed by one of the keywords below and slot/port or number information: • For a Fast Ethernet interface, enter the keyword FastEthernet followed by the slot/port information. • For a Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a SONET interface, enter the keyword sonet followed by the slot/ port information. • For a Ten Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. (OPTIONAL) Enter the keyword summary to display only the total number of CAM entries. Defaults No default behavior or values Command Modes EXEC Command History Version 7.4.1.0 Introduced on E-Series 1208 | Quality of Service (QoS)